Busbar distribution system IP55
Our company manufactures KLM-R busbar distrubution system, which replaces the cable system. KLM engineering Ltd specialists also provide services on bar system installation and maintenance. KLM busbar distribution system price is optimal.
Download pdf files
FE straight unit is used for electrical power transmission.
Pi unit is used for power transmission and distribution. This
unit allows to install tap-off unit into the special doors of the
box quickly and without hard mounting works.
FE-S unit is used for electrical power transmission.
Circulating unit is used for heat expansion in the straight
routes of busbars along more than 200 m.
Horizontal angle joint enables the busbar trunking system to achieve all
possible layouts on the horizontal plane.
Vertical angle joint enables the busbar trunking system to achieve all
possible layouts on the vertical plane.
Horizontal Z-joint is used in case of impossibility of standard horizontal
joint application.
Vertical Z-joint is used in case of impossibility of standard vertical joint
application.
Horizontal T-joint is used for taking power from busbar on the horizontal
plane.
Vertical T-joint is used for taking power from busbar on the vertical
plane.
Universal angle joint is used in case of impossibility of standard horizontal and vertical
angle-joints application.
Terminal unit is used for insulation and closing the open conducting
parts at the end of busbar route.
This unit is used for entrance to the panel and busbar connection to the
distribution board bars.
Joint unit with vertical angle is used for entrance to the panel and
connection to the distribution board bars in case of impossibility of
standard joint units application.
Joint unit with horizontal angle is used for entrance to the panel
and connection to the distribution board bars in case of impossibility
of standard joint units application.
Center feed unit is used for busbar route supply from the center
line of the route.
This unit is used for supply/taking power from busbar via flexible
cable in compliance with references.
Flexible unit is used for busbar route passing through the expansion joint
of building with route level differences.
Fire barrier provides busbar passing through the wall and floor
structures of different fıre zones with thickness 200 mm minimum.
Reducer is used for reducing the busbar discharge capacity with protection
in less powerful line parts.
Plug-in box is installed on the tapping-off doors.
Bolt-on box is installed at any mating area of two units.
ADP joint unit is used for connection with other busbar types